Loading to PV450

CustomFP · Post by **CustomFP** » Fri Apr 17, 2015 2:20 am

Hello,
I have have just installed the new version of Power Vison to a new Computer.

I am programming using an ethernet cable and single USB to Ethernet adatoptor between the PV450 and cable. The network connects I am able to debug the code over this connection.

However when I try to upload a new configuration (I've have tried both my program and the default program) I get this error (see photo).

Any advice on how to fix this would be greatly appreciated

CustomFP · Post by **CustomFP** » Fri Apr 17, 2015 2:23 am

This is previously unsed PV450. Could this be the issue.

stalley · Post by **stalley** » Fri Apr 17, 2015 8:28 am

Hello CustomFP,

Did you create a full install and upload it?

Does it reprogram with the USB? (I'm assuming the problem has been when you upload from PowerVision Configuration Studio).

CustomFP · Post by **CustomFP** » Thu May 07, 2015 8:38 pm

Hello,

I believe this was the problem. A full install and load has allowed me to get around this error.

Regards,

Loading to PV450

Loading to PV450

Re: Loading to PV450

Re: Loading to PV450

Re: Loading to PV450