Application was updated from 2.8.10356 to 2.8.10546 and was unable to read some of the free form CAN messages. Reloaded a full install from 2.8.10356 and the messages were read.
When the message was deleted and added again it them showed receiving the message.
The are a large number of messages - do we need to verify each one is correct or is this a know issue was a way of addressing?
Updated a PV780 program to 2.8.10546 cannot read some free form messages
- dwatson
- Posts: 6
- Joined: Tue Oct 11, 2011 4:12 am
- boyce
- Enovation Controls Development
- Posts: 322
- Joined: Wed Sep 08, 2010 5:09 pm
Re: Updated a PV780 program to 2.8.10546 cannot read some free form messages
Sorry that you have run into a problem. This is not a known issue.
Is it possible for you to send me the configuration in a Private Message? We will take a look to see what the problem is.
Is it possible for you to send me the configuration in a Private Message? We will take a look to see what the problem is.
Boyce Schrack
Enovation Controls
Enovation Controls
- alb
- Posts: 43
- Joined: Wed Dec 15, 2010 1:30 pm
Re: Updated a PV780 program to 2.8.10546 cannot read some free form messages
Double check Data Lengths in FFCAN Message Definition. Newer versions of PowerVision are no longer Data Length-agnostic and will filter out messages shorter/longer than the FFCAN Definition.