Dear Sir,
Would you please advise the following items? Sending sample configuration to me will be much appreciated.
1. How to convert any data from Little-endian into Big-endian and display it on PV750.
(Please find attached)
2. How to set a specified screen to be displayed automatically by bit condition of any CAN data.
Exsample: bit 1 --> GPS screen
bit 0 --> Engine Parameter screen
Thank you and best regards,
Shiii
Configuring Data
- tshiii
- Posts: 79
- Joined: Thu Sep 09, 2010 8:56 pm
Configuring Data
- Attachments
-
- Change Byte Order.xlsx
- (29.73 KiB) Downloaded 15 times
- ksaenz
- Enovation Controls Development
- Posts: 263
- Joined: Thu Aug 19, 2010 7:53 am
Re: Configuring Data
Hello Shiii,
1. To receive data with big endian byte order you can use free form CAN messages and check the box that says "Big Endian Byte Order". See document PowerVision Studio 2.3 Core for reference.
2. To change views based on CAN data you can set up state machines with event conditions and fire the event conditions on-change of the CAN data. In the attached example you can change the value of the variable manually with the upper-right button ( key 2 ).
Regards,
ksaenz
1. To receive data with big endian byte order you can use free form CAN messages and check the box that says "Big Endian Byte Order". See document PowerVision Studio 2.3 Core for reference.
2. To change views based on CAN data you can set up state machines with event conditions and fire the event conditions on-change of the CAN data. In the attached example you can change the value of the variable manually with the upper-right button ( key 2 ).
Regards,
ksaenz
- Attachments
-
- change view.zip
- Created with PVCS 2.3.11175
- (117.85 KiB) Downloaded 15 times
- tshiii
- Posts: 79
- Joined: Thu Sep 09, 2010 8:56 pm
Re: Configuring Data
Dear ksaenz,
Thank you for your prompt attention and sending the sample configuration.
Best regards,
Shiii
Thank you for your prompt attention and sending the sample configuration.
Best regards,
Shiii