Hello,
Our customer wants to use CAN-ID (8 digits) instead of PGN for each parameters and to know how to set the CAN-ID on the "Library" tab of PowerVision for the PV380-R2. Could you advise that?
Thank you,
tshiii
CAN-ID Setting/PV380-R2
- tshiii
- Posts: 79
- Joined: Thu Sep 09, 2010 8:56 pm
- boyce
- Enovation Controls Development
- Posts: 322
- Joined: Wed Sep 08, 2010 5:09 pm
Re: CAN-ID Setting/PV380-R2
I assume you are referring to an extended frame format 29-bit ID. The ID is made up of the priority, extended data page, data page, PGN and the source address. For example, the PGN definition in the Library below has the PGN 0xE000, priority 6, and the source address is 0x2B. The ID that results is 0x18E0002B. The first byte 0x18 is 00011000 in binary, 3 leading 0's, 110 priority, 0 extended data page, 0 data page. If you change the priority to 7 you will get 0x1CE0002B.
This is from using the Library tab to define the PGN. You can also use Free Form Numeric Messages and enter the Frame ID directly, like below.
This is from using the Library tab to define the PGN. You can also use Free Form Numeric Messages and enter the Frame ID directly, like below.
Boyce Schrack
Enovation Controls
Enovation Controls