I need to remove a screen from the standard 2.1 config.
But when I do, the state machine gives me errors.
Example:
If I take out the GPS screen.
I will get and " /!\ Event Log: An Action on State GPS is State Machine "Gauge Screen GoTo" appears to be invalid."
When removing an ENG screen, upon saving the config:
" /!\ Event Log: No Parameter selected for the gauge Oil Pressure Gauge"
This will list 16 widget errors like: Oil Press, Fuel Rate, Eng. Coolant Temp , Eng Speed, Oil Press, Eng 1 RPM gauge, etc.
I need to remove a screen from the standard config
- MikeEasterling
- Posts: 13
- Joined: Tue Jan 18, 2011 10:09 pm
- jpurdum
- Enovation Controls Development
- Posts: 153
- Joined: Mon Jun 21, 2010 11:19 am
Re: I need to remove a screen from the standard config
Mike -
If you haven't already, please read through the steps for adding a gauge screen to the MSTD configuration. Then try them in reverse. This is still something we hope to make easier in the future.
The steps for adding a gauge screen can be found at the post linked below:
viewtopic.php?f=7&t=68&start=0&hilit=gauge+screen
john p.
If you haven't already, please read through the steps for adding a gauge screen to the MSTD configuration. Then try them in reverse. This is still something we hope to make easier in the future.
The steps for adding a gauge screen can be found at the post linked below:
viewtopic.php?f=7&t=68&start=0&hilit=gauge+screen
john p.