I just installed the latest PowerVision 2.6.20023. I am trying to load the Murphy Standard configuration, that I just downloaded, on a PV450. When I try to load a full install from PowerVision I get this error.

The file was not transferred sucessfully due to the following error:
The Bootloader must be version 2.3.20000 or greater to support this version of PowerVision.

(side note - you may want to correct the spelling of the word successfully in this error message)

When I try to load a full install from a flash drive, I notice that the bootloader version on the PV450 is 10129. The install starts, but then it errors out with the question mark folder.

What am I doing wrong?

Thanks

Hi,

Below is a forum link which takes you to Step by step instruction to upgrade to new Bootloader. I think you might have missed a step where you upgrade the Field Programming Package. Click on the pdf link, Reliability upgrade field instructions.pdf.

viewtopic.php?f=3&t=757

Hope it helps. Please give it a try and let us know if it upgrades successfully.

Thanks,
PUplaonkar
FW Murphy