Hello,
actually I tried to use two numeric variables ( FD1 and FD2 ) which values can be changed during operation. The resulting value should survive the power cycle, so after stopping the engine and switch on again by selecting the values of FD1 and FD2 the engine should run at the certain speed. This works until stopping the unit and start again (Ignition and Bat PWR off). I've tried to change " can save " from DoNotSave to SurvivePowerCycle without success. Is it necessary to hold Bat PWR on for the display PV780 (Powervision Config Studio 2.8 R3)?
Numeric Variable should survive powercycle
- broesch
- Posts: 10
- Joined: Thu Jun 02, 2016 5:07 am
- robsinglehurst
- Posts: 54
- Joined: Fri Dec 12, 2014 6:57 am
Re: Numeric Variable should survive powercycle
Rob Singlehurst
Design Engineer
Briggs Irrigation
Boyle Road
Corby
Northants.
England
UK
Design Engineer
Briggs Irrigation
Boyle Road
Corby
Northants.
England
UK