Hello,

When a new configuration was uploaded to PV450-NV, it seems to be done successfully on PowerVision screen, but the attached error was shown on the PV450-NV and could be uploaded actually. Both the new configuration and originally installed one in the PV450-NV were created by the same version 2.7. Then, I tried to upload it by USB flash memory, but the same error was found. Could you advise how to approach this?

Thank you,
tshiii

has the screen had a complete/full firmware & application load before?

I'd try creating a 'full' load, and save that to the stick, which should produce a file like update_full.gz

then load that via usb.