Compact, Encapsulated Module for Data Exchange between Two CAN Networks.

The Enovation Controls CANBridge is a compact module designed to enable the exchange of CAN communication data between two CAN networks. This can facilitate data exchange between networks operating at different baud rates. A software configuration tool simplifies setup and allows users to save configuration settings in a file for future use.

CANBridge can be configured to allow the exchange of all CAN messages between the two networks, limit data exchange in one direction only, or filter bidirectionally on 11 or 29-bit identifiers. Additionally, the unit allows for using SAE J1939/NMEA2000 rules. J1939 data can be filtered independently on the source address and PGN in both directions. This filtering supports up to 16 combinations of source address and PGN. NMEA2000 has the same options for filtering as J1939 but adds a method for each of the 16 filters to reduce CAN traffic by retransmitting only every nth message. The NMEA filters also support fast-packet. CANBridge is compact and light enough for inclusion in many wiring harnesses, but can also be surface mounted via four fixing holes. The case is fully sealed in epoxy resin for high impact and environmental resistance.

 WARNING: This product may expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information about California Propsition 65, go to www.P65Warnings.ca.gov or visit our California Proposition 65 page.

• CANBridge Datasheet

Additional product documentation can be found on our product support website or by clicking the Help Center button above.